tiller help please

[stuckinthemud]

Morning!

I am in danger of perfecting this into the bin but the limbs are not quite balanced and I cannot see why. I could really do with a fresh pair of eyes on this.  Thanks in advance.
Andrew

[Del the cat]

Looks a bit stiff just above centre...
E.G. In the top pic, the lower limb looks ok, top limb stiff just above where it is supported, (above the fade).
Del

[stuckinthemud]

Done a little scraping here and therr.  How's it look?

[Aksel]

Looks pretty even, lower limb might bend more even, upper more at the fade. Lower limb might look a little stiffer but it can all be due to the angle of the photo. is it taking any set?

[stuckinthemud]

It took a small amount of set early on in the process but has not taken on any additional set recently. even after getting past brace. Here's the really wierd thing, I could just squeeze my middle finger through the gap between the centre and the bench, but they both rubbed the skin, then I tempered the bow - only a light tempering, and the bow was not strapped down - and then re-measured the set and it has almost all disapeared.  Long and short, one limb has no set, the other has a natural deflax-reflex curve which has taken on about 1/4" of additional set

[stuckinthemud]

Been working on it a little bit, now got it to full draw, its showing a bit under 1cm of set in the outer 1/3 of both limbs.  I think I may have gone one scrape too far on the top limb?  I kinda want to scrape at the centre of the bottom limb just once or twice, but, I may be bettter putting a few shots through it and then see where I am.  Really could do with some input on this please

[Pat B]

Looks a bit stiff just to the left of center to me. Otherwise she looks good. 

[superdav95]

Looks a bit stiff just to the left of center to me. Otherwise she looks good.

That’s what I see too.