Author Topic: Pic test  (Read 3700 times)

0 Members and 1 Guest are viewing this topic.

Offline Woody roberts

  • Member
  • Posts: 179
Pic test
« on: September 14, 2020, 10:57:05 am »
Some points I beat out of an old lawn mower blade.

Offline Hawkdancer

  • Member
  • Posts: 5,040
Re: Pic test
« Reply #1 on: September 14, 2020, 12:14:35 pm »
Nice!  Loaded for bear in chain mail >:D (lol) (SH)!  There is life after mowing!  I have a couple of old mower blades looking for a next life!  I thought about neck knives or points.
Hawkdancer
Life is far too serious to be taken that way!
Jerry

Offline Woody roberts

  • Member
  • Posts: 179
Re: Pic test
« Reply #2 on: September 14, 2020, 12:31:23 pm »
Here is another refurbished lawn mower blade.

Offline Trapper Rob

  • Member
  • Posts: 3,719
Re: Pic test
« Reply #3 on: September 14, 2020, 07:04:07 pm »
You do nice work

Offline Morgan

  • Member
  • Posts: 1,028
Re: Pic test
« Reply #4 on: September 14, 2020, 08:04:26 pm »
Good stuff. What did you use for quench and How well did them blades harden? I have several jd mower blades that are supposed to be good steel similar to 5160 or 52100. I tried hardening a small piece off of one in canola oil and it didn’t take. I’ll try again with different quenches.

Offline Woody roberts

  • Member
  • Posts: 179
Re: Pic test
« Reply #5 on: September 14, 2020, 08:29:54 pm »
Oil didn’t work for me either. I quench in water and I don’t draw back. Just leave them as quenched. Ive made several. Very tough and springy. Harder than a factory Case knife which I like. I was an electrician before I retired and used my work knife to ream conduit with. It will shave a sliver off of EMT without dulling.

Reasonably easy to get an edge on.

Offline Woody roberts

  • Member
  • Posts: 179
Re: Pic test
« Reply #6 on: September 14, 2020, 08:37:55 pm »
Here is my work knife. The insert is from a Klein 11 in 1. Phillips on one end, straight on the other and a 1/4” nut driver. Scales are Cherry.