« previous next »
Pages: [1]

Author Topic: It is knot a problem... or is it?  (Read 1586 times)

0 Members and 1 Guest are viewing this topic.

Offline Jakesnyder

  • Member
  • Posts: 458
It is knot a problem... or is it?
« on: March 31, 2019, 06:06:31 am »
Heres a piece of red oak. Just wondering if this knot is a problem in the location it is in. I'm going for a 55" bendy handle. It is 1.75" at its widest point. My goal is 45lbs at 24".
Logged

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,633
Re: It is knot a problem... or is it?
« Reply #1 on: March 31, 2019, 06:19:20 am »
Get those corners rounded off and give it a shot. Looks like it's far enough over from the edge on the back but keep the back and belly edged rounded as you go.
Logged
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

Offline George Tsoukalas

  • Member
  • Posts: 9,425
    • Traditional and Primitive Archers
Re: It is knot a problem... or is it?
« Reply #2 on: March 31, 2019, 06:19:31 am »
Just try to leave wood around that knotted area and tiller that knot to appear slightly stiffer than the rest of the limb. Jawge
Logged
Set Happens!
If you ain't breakin' you ain't makin!

Offline DC

  • Member
  • Posts: 10,396
Re: It is knot a problem... or is it?
« Reply #3 on: March 31, 2019, 08:05:23 am »
Have you narrowed the tips yet? I can't tell with the camera angle. If you haven't try and keep the knot in the middle of the limb unless of course you can take off enough to eliminate it.
Logged

Offline willie

  • Member
  • Posts: 3,268
Re: It is knot a problem... or is it?
« Reply #4 on: March 31, 2019, 08:12:16 am »
follow the grain around the knot if you can so that the (wood width outside the knot) plus (the wood width inside the knot)  totals the same as the rest of the limb in that area.
Logged
Pages: [1]
« previous next »