doomed??more questions!!!!!

[4dog]

so is this a bow killer or what..its a drying check that i tried to superglue its holding right now but im barely at floor tiller ...goes from back to belly on this side only.

[bubby]

look's to me like most will be gone by the time ya narrow the tips, and leave the tips non bending , I assume that is a tip seems wide

[ohma2]

Same here you still have room for a tip there.

[BOWMAN53]

how wide is it?

[IdahoMatt]

Is that a side view or the back or belly?  If it is a side view.  Is the right or left the back?  Looks like it could work out.

[4dog]

side view..left is back right is belly.  but goes to almost center of tip..the crack i mean....lol

[BOWMAN53]

how wide is the limb? if its wide enough and the check in shallow enough you can narrow it and itll go away.

[DarkSoul]

Just sand the tip to an angle of about 30 degrees and glue a hardwood tip overlay onto the crack. Should be no problem then!

[Onebowonder]

Just sand the tip to an angle of about 30 degrees and glue a hardwood tip overlay onto the crack. Should be no problem then!

+1

OneBow

[bubby]

this will work nice

[4dog]

bubby is the weiner...thatll wrk...!!!!

[4dog]

now im thinkin pyramid with levers ..would this work?

[4dog]

where the line is...lose the taper..this is side profile.

[4dog]

this is the back...from the side profile i could thin the check out of it..i think..but still have the depth for strength..just a guess on my part.

[bubby]

I can't tell from the pics but the levers / tips won't bend so your prolly good to go, remember the levers only have to be a little thicker to not bend but if the tips get real narrow leave a little more thickness