Author Topic: Hackberry Log  (Read 3664 times)

0 Members and 1 Guest are viewing this topic.

Online Pappy

  • Global Moderator
  • Member
  • Posts: 31,902
  • if you have to ask you wouldn't understand ,Tenn.
Re: Hackberry Log
« Reply #15 on: October 31, 2013, 06:59:07 am »
Like JW said twist is not a problem with Hackberry,and yes you should be able
to tell the top ring when you get through the bark,just go slow and scrape if necessary.  :) I seal most any wood when I remove the bark,sometimes it won't cause a problem if you don't but ant worth the chance,sealing them ant hard. ;) :)
 Pappy
Clarksville,Tennessee
TwinOaks Bowhunters
Life is Good

Offline Gaust

  • Member
  • Posts: 153
Re: Hackberry Log
« Reply #16 on: October 31, 2013, 11:59:14 am »
Thanks, JW.  That's good to know.  I have a couple of staves that will have to be eventually straightened.

Dark Soul, do I take off the brittle soft stuff directly underneath the bark at this time?  Or can I store it with that on for my drying period?

George

Offline Gaust

  • Member
  • Posts: 153
Re: Hackberry Log
« Reply #17 on: October 31, 2013, 04:55:00 pm »
Just answered my own question.  I removed the brittle stuff down to the first growth ring and sealed the back with Elmer's glue.  That's one down and four to go.
George

Offline toomanyknots

  • Member
  • Posts: 3,132
Re: Hackberry Log
« Reply #18 on: October 31, 2013, 09:44:08 pm »
Bought a sledge hammer



:) I always just use another piece of wood, usually a big fat honeysuckle trunk,  8).
« Last Edit: November 01, 2013, 09:01:24 pm by toomanyknots »
"The way of heaven is like the bending of a bow-
 the upper part is pressed down,
 the lower part is raised up,
 the part that has too much is reduced,
 the part that has too little is increased."

- Tao Te Ching, 77, A new translation by Victor H. Mair

Offline Gaust

  • Member
  • Posts: 153
Re: Hackberry Log
« Reply #19 on: November 01, 2013, 04:31:38 pm »
Wondering if would be better to rough out a bow from a stave before setting it aside to dry out.  Any suggestions?
George