« previous next »
Pages: [1] 2

Author Topic: Finally repaired Grampie's old bow  (Read 6108 times)

0 Members and 1 Guest are viewing this topic.

Offline Olanigw (Pekane)

  • Member
  • Posts: 488
Finally repaired Grampie's old bow
« on: March 21, 2013, 03:21:23 pm »
Hey everyone,

I have an old FG longbow that my grandfather hunted with.  It's starting to delaminate at the tips and I want to get it fixed sooner rather than later, for sentimental reasons.

Can anyone recommend a Bowyer in the Northeast that is reputable, will take a look and see if it can ever shoot again?

Thanks for the consideration.

EDIT:  PICS BECAUSE IM A KNUCKLEHEAD (Thanks Pat B for reminding me)





That's the extent of it.  The gel coat is just starting t bubble in other areas, but I'm not worried about that.
« Last Edit: June 21, 2013, 10:07:36 am by Pekane »
Logged
"Good enough" is the enemy of great
PN501018

Online Pat B

  • Administrator
  • Member
  • Posts: 37,637
Re: Any recommendations for FG repairs?
« Reply #1 on: March 21, 2013, 03:36:57 pm »
If not too bad a little super glue might just fix it for you. Will you post pics?
Logged
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

Offline Stoker

  • Member
  • Posts: 1,729
Re: Any recommendations for FG repairs?
« Reply #2 on: March 22, 2013, 03:58:42 pm »
Epoxy will do it. Glue and lighty clamp. Let it fully cure befor shooting.
Thanks leroy
Logged
Bacon is food DUCT tape - Cipriano

Offline jeffhalfrack

  • Member
  • Posts: 438
Re: Any recommendations for FG repairs?
« Reply #3 on: March 22, 2013, 05:05:46 pm »
  That's  nothing!  gorilla impact glue!   it's a super glue I use it to glue limb tips on fg bows good stuff  I breathe on it like you are about to clean your glasses  CA type glues  are water activated go for it   good luck JeffW
Logged

Offline mullet

  • Global Moderator
  • Member
  • Posts: 22,913
  • Eddie Parker
Re: Any recommendations for FG repairs?
« Reply #4 on: March 22, 2013, 06:10:08 pm »
Loctite Thin super glue and a clamp. :)
Logged
Lakeland, Florida
 If you have to pull the trigger, is it really archery?

Offline Olanigw (Pekane)

  • Member
  • Posts: 488
Re: Any recommendations for FG repairs?
« Reply #5 on: March 22, 2013, 07:16:43 pm »
thanks guys!
Logged
"Good enough" is the enemy of great
PN501018

Offline Olanigw (Pekane)

  • Member
  • Posts: 488
Re: Any recommendations for FG repairs?
« Reply #6 on: April 12, 2013, 11:18:09 am »
I finally got some time to glue it up.

It didn't take...  All of the pressure from my clamp was on the middle and didn't do much for the "ears".  I will need to figure out how to use some vice grips to clamp it where it needs it.

Try again, maybe tonight, maybe when I get back from Mexico next weekend.
Logged
"Good enough" is the enemy of great
PN501018

Offline Joec123able

  • Member
  • Posts: 1,769
Re: Any recommendations for FG repairs?
« Reply #7 on: April 12, 2013, 08:52:28 pm »
Had it happen to me I just glued it back down with tite bond 2 still shoots fine
Logged
I like osage

Offline JackCrafty

  • Global Moderator
  • Member
  • Posts: 5,628
  • Sorry Officer, I was just gathering "materials".
Re: Any recommendations for FG repairs?
« Reply #8 on: April 12, 2013, 09:14:42 pm »
Wax is often recommended for a final finish over Gelcoat.  If wax has crept in and facilitated the delamination, any amount of glue will NOT fix it.  Glue will not stick to wax.  Before you go any further I recommend you determine exactly why the wood lams are separating.  If you can't figure it out, then it's best to find a good bowyer like you mentioned.

Hopefully the glue you used is a good base for more glue.  If it's not, then the glue will have to be removed before the repair can be done.

Good luck.  Looks like a beautiful bow!
Logged
Any critter tastes good with enough butter on it.

Patrick Blank
Midland, Texas
Youtube: JackCrafty, Allergic Hobbit, Patrick Blank

Where's Rock? Public Waterways, Road Cuts, Landscape Supply, Knap-Ins.
How to Cook It?  200° for 24hrs then 275° to 500° for 4hrs (depending on type), Cool for 12hr

Offline sleek

  • Member
  • Posts: 6,765
Re: Any recommendations for FG repairs?
« Reply #9 on: April 13, 2013, 04:30:28 am »
I would fill it full of a gel loctite super glue, then use wax paper over a board, and clamp it down, using the board for evenly applied pressure and the wax paper to keep from gluing your board to to the bow.
Logged
Tread softly and carry a bent stick.

Dont seek your happiness through the approval of others

Offline chamookman

  • Member
  • Posts: 3,027
Re: Any recommendations for FG repairs?
« Reply #10 on: April 13, 2013, 01:48:25 pm »
Pekane - I've looked at the pics quite a few times now, and I'm not sure that is FG backing. I believe it is Fortisan - used quite a bit pre - FG. I have an OLD Lemonwood Longbow that is a BRUTE, that was backed with Fortisan. The backing started to delam and I tried many differant glues to lay the backing down with no sucsess (It was a wall hanger). The backing eventually totally fell off. Good luck - Bob.
Logged
"May the Gods give Us the strength to draw the string to the cheek, the arrow to the barb and loose the flying shaft, so long as life may last." Saxon Pope - 1923.

Offline JackCrafty

  • Global Moderator
  • Member
  • Posts: 5,628
  • Sorry Officer, I was just gathering "materials".
Re: Any recommendations for FG repairs?
« Reply #11 on: April 13, 2013, 02:19:12 pm »
Guys, the belly lam is the one delaminating, no?  I assume we are looking at a recurve.  Look at the way the string notch is cut...
Logged
Any critter tastes good with enough butter on it.

Patrick Blank
Midland, Texas
Youtube: JackCrafty, Allergic Hobbit, Patrick Blank

Where's Rock? Public Waterways, Road Cuts, Landscape Supply, Knap-Ins.
How to Cook It?  200° for 24hrs then 275° to 500° for 4hrs (depending on type), Cool for 12hr

Offline chamookman

  • Member
  • Posts: 3,027
Re: Any recommendations for FG repairs?
« Reply #12 on: April 13, 2013, 02:24:10 pm »
Good catch there Patrick ! Wow - I sure missed that one  :-X :-X. Bob
Logged
"May the Gods give Us the strength to draw the string to the cheek, the arrow to the barb and loose the flying shaft, so long as life may last." Saxon Pope - 1923.

Offline JackCrafty

  • Global Moderator
  • Member
  • Posts: 5,628
  • Sorry Officer, I was just gathering "materials".
Re: Any recommendations for FG repairs?
« Reply #13 on: April 13, 2013, 02:27:32 pm »
Izz ok.   ;)
Logged
Any critter tastes good with enough butter on it.

Patrick Blank
Midland, Texas
Youtube: JackCrafty, Allergic Hobbit, Patrick Blank

Where's Rock? Public Waterways, Road Cuts, Landscape Supply, Knap-Ins.
How to Cook It?  200° for 24hrs then 275° to 500° for 4hrs (depending on type), Cool for 12hr

Offline bubby

  • Member
  • Posts: 11,054
Re: Any recommendations for FG repairs?
« Reply #14 on: April 14, 2013, 04:12:55 am »
clean it well, good ca glue and innertube wrap it as the clamp
Logged
failure is an option, everyone fails, it's how you handle it that matters.
The few the proud the 27🏹
Pages: [1] 2
« previous next »