« previous next »
Pages: [1]

Author Topic: Best way to make a recurves nocks able to be strung with a stringer?...  (Read 1719 times)

0 Members and 2 Guests are viewing this topic.

Offline toomanyknots

  • Member
  • Posts: 3,132
Best way to make a recurves nocks able to be strung with a stringer?...
« on: November 20, 2012, 10:32:35 pm »
I was just wondering what everyone's thoughts are on the best way to make a recurves nocks able to be strung with a stringer, other than making 2 nocks on the top limb. Would making a long narrow pin nock like on fiberglass bows be best?  So that you could use a traditional pouch stinger with? This is the nock style I am talking about:




Logged
"The way of heaven is like the bending of a bow-
 the upper part is pressed down,
 the lower part is raised up,
 the part that has too much is reduced,
 the part that has too little is increased."

- Tao Te Ching, 77, A new translation by Victor H. Mair

Offline simson

  • Member
  • Posts: 2,310
  • stonehill-primitive-bows
    • stonehill-primitive-bows
Re: Best way to make a recurves nocks able to be strung with a stringer?...
« Reply #1 on: November 21, 2012, 01:01:07 am »
Logged
Simon
Bavaria, Germany

Offline George Tsoukalas

  • Member
  • Posts: 9,425
    • Traditional and Primitive Archers
Re: Best way to make a recurves nocks able to be strung with a stringer?...
« Reply #2 on: November 21, 2012, 07:28:52 am »
I just fit the nocks to the stringer using a file or sander but I just make regular nocks with no overlays. Jawge
Logged
Set Happens!
If you ain't breakin' you ain't makin!
Pages: [1]
« previous next »