« previous next »
Pages: [1]

Author Topic: osage board pieces  (Read 3657 times)

0 Members and 1 Guest are viewing this topic.

Offline JEB

  • Member
  • Posts: 1,735
osage board pieces
« on: July 06, 2020, 07:47:34 am »
Still looking for some smaller 1/4" TO 3/8th's thick pieces of osage board to be used for butt caps on my knife handles. They don't need to be real long, 1 1/2" or so as I trim them down to about the size of a quarter.  I have some 4" or 5" die cut RIGHT feathers or some full length LEFT wing feathers for trade.
Logged

Offline Eric Krewson

  • Member
  • Posts: 5,417
Re: osage board pieces
« Reply #1 on: July 12, 2020, 02:54:49 pm »
Give me the dimensions and grain orientation and I will send you some for free, I have a lot of cut off scrap.
Logged

Offline JEB

  • Member
  • Posts: 1,735
Re: osage board pieces
« Reply #2 on: July 12, 2020, 05:18:18 pm »
1/4 to 3/8ths thick and at least 1 1/2" long. I use them for butt sections on stone knives so after being attached and sanded they are usually around the size of a quarter when done. But a little longer board is good so I can get more caps to use. Thanks for your help Eric.
Logged

Offline Eric Krewson

  • Member
  • Posts: 5,417
Re: osage board pieces
« Reply #3 on: July 13, 2020, 08:01:12 am »
Do you want end cut or or rift sawn? PM me your address.

End cut;

Logged

Offline mullet

  • Global Moderator
  • Member
  • Posts: 22,911
  • Eddie Parker
Re: osage board pieces
« Reply #4 on: July 14, 2020, 10:26:41 am »
If Eric's doesn't work for you I could turn an osage dowel on the lathe and you could slice off what you need.
Logged
Lakeland, Florida
 If you have to pull the trigger, is it really archery?

Offline JEB

  • Member
  • Posts: 1,735
Re: osage board pieces
« Reply #5 on: July 14, 2020, 12:18:15 pm »
Thanks Eddie but I should be good for now.
Logged
Pages: [1]
« previous next »