« previous next »
Pages: [1]

Author Topic: Erc sapwood question  (Read 1551 times)

0 Members and 1 Guest are viewing this topic.

Offline TimothyR

  • Member
  • Posts: 658
  • PM110782
Erc sapwood question
« on: February 21, 2016, 10:00:58 pm »
I'm working on an erc bendy and wanted to know if I was to put deflex in the handle and flip the tips a bit. Do I use dry heat or steam?  I'm going to rawhide back it with a diamondback over that. I want to get around 26-27" draw out of it. It is 54" long  and 1 1/2" at the fades. And do i heat treat the belly? Thank you for any advice Tim
Logged
Freedom dies one compromise at a time. III%

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,633
Re: Erc sapwood question
« Reply #1 on: February 21, 2016, 10:40:36 pm »
I've never done it but I think I'd use steam.
Logged
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

Offline Aaron H

  • Member
  • Posts: 3,437
Re: Erc sapwood question
« Reply #2 on: February 22, 2016, 07:18:27 am »
I have used both steam and dry heat, steam seems to work better as it does with most woods imo.  I have not done any extreme bends with erc, but it takes gentle bends well.
Logged

Offline Josh B

  • Member
  • Posts: 3,741
Re: Erc sapwood question
« Reply #3 on: February 22, 2016, 07:54:24 am »
Steam is better to make the bend.  After its clamped into shape I use dry heat to sort of set the bend.  That piece is a bit undersized for what you are trying to do.  Rawhide is probably not going to be enough to hold that together.  Sinew would be the only thing I would try to make such a short and narrow piece of ERC bend that far.  Josh
Logged
Pages: [1]
« previous next »