Author Topic: Nock point  (Read 2140 times)

0 Members and 1 Guest are viewing this topic.

Offline bow101

  • Member
  • Posts: 2,235
Nock point
« on: April 22, 2014, 08:23:02 pm »
Most of you place the nock point on the string 3/8" above dead center wheather you place the arrow above the nock point of below.....?  If it is above that would give it another 11/32" over for that size of arrow;
"The privilege of a lifetime is being who you are."  Joseph Campbell

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,637
Re: Nock point
« Reply #1 on: April 22, 2014, 08:53:25 pm »
I shoot a bow a lot without a nock after I build it. If it is for someone else I don't add a nock so they can set the bow up for themselves but if it is for me I figure where it shoots best and set the nock up for that. I nock over.
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

Offline Eric Krewson

  • Member
  • Posts: 5,434
Re: Nock point
« Reply #2 on: April 22, 2014, 11:41:04 pm »
I never measure where a nock might go. Shoot the bow, and move the nock up and down until you get the best arrow flight and run with that setting.

Offline Pappy

  • Global Moderator
  • Member
  • Posts: 32,206
  • if you have to ask you wouldn't understand ,Tenn.
Re: Nock point
« Reply #3 on: April 23, 2014, 07:25:58 am »
I start at about 1/4 above and move up and down until I get the flight I want,then mark and tie it in. I put the arrow below the nock. :)
   Pappy
Clarksville,Tennessee
TwinOaks Bowhunters
Life is Good

Offline mullet

  • Global Moderator
  • Member
  • Posts: 22,913
  • Eddie Parker
Re: Nock point
« Reply #4 on: April 23, 2014, 08:43:21 am »
It helps to have a B-50 string stretched in, too, or you will be moving it when it finally does stretch.
Lakeland, Florida
 If you have to pull the trigger, is it really archery?

Offline adb

  • Member
  • Posts: 5,339
Re: Nock point
« Reply #5 on: April 23, 2014, 11:35:08 am »
I set my nock point 1/2" above square and nock under.

Offline bow101

  • Member
  • Posts: 2,235
Re: Nock point
« Reply #6 on: April 23, 2014, 01:53:04 pm »
Have read elsewhere that many just place the nock at 3/8" as a starting point or 1/2" and adjust from there.   Guess I should of asked what a good starting point was.   Makes sense now.
"The privilege of a lifetime is being who you are."  Joseph Campbell