« previous next »
Pages: [1]

Author Topic: Bending Iron Wire  (Read 4095 times)

0 Members and 1 Guest are viewing this topic.

Offline Darto

  • Member
  • Posts: 3
Bending Iron Wire
« on: March 19, 2013, 05:58:51 am »
I bought this helmet stand (for displaying medieval/reenactment armor) online, costs $10 or $15 or some such.
Made of heavy iron wirelike material , finished in some sort of black substance, supposed to be authentic middle ages metal finish substance.

Anyways 1/4" heavy iron is probably difficult to bend into these types of shapes? Need a forge perhaps?
Been using this in mountains where ground to rocky to pierce.

Logged

Offline Stoker

  • Member
  • Posts: 1,729
Re: Bending Iron Wire
« Reply #1 on: March 19, 2013, 10:56:13 am »
If you paid 10-15 for it. Most likely cold rolled steel wire. Bender/roller will do it. No heat needed. A vice and a peice of pipe will work too.
Thanks Leroy
Logged
Bacon is food DUCT tape - Cipriano

Offline Darto

  • Member
  • Posts: 3
Re: Bending Iron Wire
« Reply #2 on: March 19, 2013, 03:10:10 pm »
Oh, OK, steel. It is made by Epic Armoury in Denmark, I think all their armor suits and helmets etc. are made of the same metal. I thought probably iron, but thanks, I guess it is steel. They just say 'metal' on the label.
Logged

Offline Thesquirrelslinger

  • Member
  • Posts: 1,245
Re: Bending Iron Wire
« Reply #3 on: March 25, 2013, 03:04:37 am »
Try a heavy pliers/vice grips and your foot. That is what i do, and I am 14 yrs old, 5'3.
-squirrel
Logged
"Insanity is doing the same thing over and over again and expecting different results"
Pages: [1]
« previous next »