« previous next »
Pages: [1]

Author Topic: Backing strip question.  (Read 1058 times)

0 Members and 1 Guest are viewing this topic.

Offline autologus

  • Member
  • Posts: 1,092
Backing strip question.
« on: January 02, 2013, 11:09:05 pm »
Will it work OK if the wood backing strip is in two pieces or should it be a single piece?  I have some nice Ash that would make some good backings but its only 55 inches long.  I could do a kerf splice at the handle.

Grady
Logged
Proud Hillbilly from Arkansas.

Offline Knapper

  • Member
  • Posts: 1,057
  • David Atnip
Re: Backing strip question.
« Reply #1 on: January 02, 2013, 11:51:22 pm »
If it's not bending in the handle two pieces shouldn't matter. A handle wrap would cover whatever type of joint you make :)
Knapper
Logged
Ad Dare Servire
PM104250

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,633
Re: Backing strip question.
« Reply #2 on: January 03, 2013, 12:35:07 am »
You can also put an overlay over the joint then shape it so it fills your hand when you grip the bow. The overlay will add lots of strength to the backing joint.
Logged
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

Offline Eastman

  • Member
  • Posts: 88
Re: Backing strip question.
« Reply #3 on: January 03, 2013, 11:57:13 am »
I've let two hickory backing strips overlap by about 1/4'' in the middle of a bendy handle bow.(although I guess a bit longer is better)
and it's only wrapped with some art sinew at that part. It hasn't caused any problems for me  :)
Logged
''The joy is great of him who strays, in shady woods on summer days, With eyes alert and muscles steady , His long-bow strung, his arrows ready''  -Maurice Thompson
Pages: [1]
« previous next »