I was at one of our big store 'hardware' places yesterday and thought I would just check the Red Oak. I am wanting to learn (experiment) with heat bending & treating. Nothing worth buying in the 3/4" stuff but I could not believe what I found in the 1.5 x 1.5 bin. Two 6 foot pieces with straight grain. Snagged them both. I then looked in the Hickory and found a 1.5" x .75" x 8' sapwood piece with pretty straight grain. Got the whole bunch.
This afternoon I ripped the oak into .75" x 1.5" then cut them to lengths. Hickory is going to be 56" ntn. The RO will be: 60", 62", 64", & 66".
I also finished some culls to tomorrow I am going to start on these. I would like them all to come in @ 27" draw in the 40-45 lb range.