« previous next »
Pages: [1]

Author Topic: Question on a osage bow  (Read 2791 times)

0 Members and 1 Guest are viewing this topic.

Offline Dave 55

  • Member
  • Posts: 243
Question on a osage bow
« on: February 01, 2009, 12:24:22 pm »
GUYS i have a question on a osage stave I started working on.When it was split it pulled so much heartwood out under the sapwood that when I squared it up I had a 1and 1/2 inch stave but after removing the sapwood I found a knot right on the working edge of the limb and dont imagine the limb would hold like that.I could go 1and 1/4 inches and try to make an american longbow type bow.
Any thoughts would be greatly appreciated,Dave.
Logged
Now is the good old days

Offline DanaM

  • Member
  • Posts: 9,211
Re: Question on a osage bow
« Reply #1 on: February 01, 2009, 12:31:34 pm »
Picture would help but it sounds like a canidate for a rawhide backing.
Logged
"Prosperity is a way of living and thinking, and not just money or things. Poverty is a way of living and thinking, and not just a lack of money or things."

Manistique, MI

Offline Dave 55

  • Member
  • Posts: 243
Re: Question on a osage bow
« Reply #2 on: February 01, 2009, 01:25:55 pm »
Thanks for the reply Dana I know I have to work on the picture posting deal,not too computer smart is the problem.
Logged
Now is the good old days

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,618
Re: Question on a osage bow
« Reply #3 on: February 01, 2009, 01:36:53 pm »
Dave, 1 1/4" wide is fine for an osage bow. If you can eliminate the knot and still get 1 1/4", go for it!  What is the length of your stave and what draw weight and length are you going for?    Pat
Logged
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

Offline Dave 55

  • Member
  • Posts: 243
Re: Question on a osage bow
« Reply #4 on: February 01, 2009, 01:48:31 pm »
Pat the length of the stave is 68 inches,Id like to get around 60# at 26.Going 1and1/4 inches would alow me to eliminate the knot from the bow,as always thanks for the info,Dave.
Logged
Now is the good old days

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,618
Re: Question on a osage bow
« Reply #5 on: February 01, 2009, 01:52:05 pm »
With 1 1/4" and 68" you can easily make 60#@26". You could even go to 66" or 64" if you wanted, especially with your 26" draw.   
Logged
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

Offline adb

  • Member
  • Posts: 5,339
Re: Question on a osage bow
« Reply #6 on: February 01, 2009, 02:58:41 pm »
I just finished a maple backed osage, which is 1.25" at center, and it has a knot on the edge, right in the middle of the upper limb. It's 72" NTN, and tillered out to 29". You should be fine. I did back it, because of that knot.
Logged
Pages: [1]
« previous next »