is my project doomed from the start?

[Zugul]

I've gained 1 1/2 inches of draw and to me it seems like the inner half of both limbs is bending decently while the outher half is pretty stiff (left outer 1/2 limb stiffer then the right one). What do you guys think?

[Zugul]

After a long pause I got at this bow again, now it's finally at low brace height. I also corrected the deflex between the knot and the end of the left limb, to make it easier to judge the bend there. To my eye the bow seems a bit stiff in the inner 1/3 of each limb and in the knot area, what do you guys think?

[superdav95]

Yup that’s what I see too.  Looking good though.  Get it to brace and then get better idea on how the bend is coming from brace.  The bend draw will look different from brace. 

[Zugul]

Finally managed to get the bow to a 5" brace height, after getting it to 35# at  a little more then 14" when it was at a shorter brace. It started getting a bit of set (1/2") pretty spread out along both limbs but there's a touch more of it at the wiggle on the right of the middle of the bow, so that area wil stay untouched. Other than that I'd say it can bend a touch more right in the middle, thoughts? After that adjustment I'd just keep getting the weight down while I approach draw lenght 

[Zugul]

I did a few little tweaks and brought the brace height up to 6", the weight is now at 35# at 16". Set did not increase so it seems like I'm on the right track, maybe the right limb is still a bit stiff around mid limb. From now it should be only a matter of adjusting the right limb and then even mass removal and frequent tiller checks, correct?
If you click on the image you'll be sent to the one I posted on flickr, where you can zoom on it if needed to better judge the bend

[Pappy]

Looking really good to my eyes. Pappy

[superdav95]

Me too