« previous next »
Pages: [1]

Author Topic: Compressed shafts at home?  (Read 2892 times)

0 Members and 1 Guest are viewing this topic.

Offline Red Dwarf

  • Member
  • Posts: 121
Compressed shafts at home?
« on: May 26, 2008, 02:38:09 am »
Is it practical to compress your own shafts?
I would like to compress 11/32 down to 5/16 and would welcome suggestions as to the best methods/tools.


Thanks


Red Dwarf
Logged

Offline 1/2primitive

  • Member
  • Posts: 1,026
  • Bible believing Christian
Re: Compressed shafts at home?
« Reply #1 on: May 26, 2008, 03:19:21 pm »
I know you can buy a block that has holes through it from 3 Rivers. You use a drill and push a shaft through one of the holes at the same time, I believe. It compresses the shafts.
    Sean
Logged
Dallas/Fort Worth Tx.

Offline markinengland

  • Member
  • Posts: 698
Re: Compressed shafts at home?
« Reply #2 on: May 26, 2008, 07:30:53 pm »
I have reduced shafts using a hole gauge.
I pulled the shafts through successively smaller holes attached to a high speed drill.
When the edges of the holes are sharp they cut, when dulled they compress. If the holes reduce by 1/64th each time and the edges are rounded I think it would work.
Mark in England
Logged
Pages: [1]
« previous next »