« previous next »
Pages: 1 [2]

Author Topic: Help designing recurve  (Read 2179 times)

0 Members and 1 Guest are viewing this topic.

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,542
Re: Help designing recurve
« Reply #15 on: April 18, 2017, 10:24:34 pm »
Filip, the tips at the recurve(apex of the curve)have to be thicker but it can taper to the tips,3/8" or less at the string groove. Ideally you want them just thick enough so they don't bend at full draw. It seems to me 1/2" thick but you can be narrowed quite a bit. Thick and narrow is stronger and lighter than thin and wide.
Logged
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

Offline FilipT

  • Member
  • Posts: 821
Re: Help designing recurve
« Reply #16 on: April 19, 2017, 01:48:52 am »
So I could make usual taper from fades to the tips with tips being before recurving about 1/2" thick and when I finish tillering to go for narrowing them?

Would you say a bit over 1" wide at the tips for beginning is enough?
Logged
Pages: 1 [2]
« previous next »