Author Topic: Black locust log.  (Read 2254 times)

0 Members and 1 Guest are viewing this topic.

Offline bentstick54

  • Member
  • Posts: 770
Black locust log.
« on: March 13, 2017, 10:08:39 pm »
Found a black locust tree truck that had been cut and left on the ground for a week in the woods. It is approximately 8' long and maybe 10" diameter. No visibable checking yet. Weather has been in the mid 40s to md 50s and dry. A friend loaded it up and was going to take it home and seal the ends for me until I could go back and get it.
Do you think it will still be usable for selfbows? How fast will black locust deteriorate internally?
« Last Edit: March 22, 2017, 09:18:03 pm by bentstick54 »

Offline BowEd

  • Member
  • Posts: 9,390
  • BowEd
Re: Black locust log.
« Reply #1 on: March 13, 2017, 10:14:36 pm »
I'd get it split up.Bark and sapwood off to a heartwood ring as soon as possible.Shellac the ends and back then too.
BowEd
You got to stand for something or you'll fall for anything.
Ed

Offline turtle

  • Member
  • Posts: 1,069
  • PA1007207
Re: Black locust log.
« Reply #2 on: March 13, 2017, 10:28:20 pm »
Black locust is very rot resistant.  But sometimes fungus will get in it. In 40 and 50 degree dry weather I think it should be fine.
Steve Bennett

Offline bentstick54

  • Member
  • Posts: 770
Re: Black locust log.
« Reply #3 on: March 13, 2017, 10:41:39 pm »
Thanks guys, it looked to good to leave lay. Have never worked with black locust but wanted to give it a try. But definitely want to start with good wood.

Offline osage outlaw

  • Member
  • Posts: 11,962
Re: Black locust log.
« Reply #4 on: March 13, 2017, 10:58:21 pm »
I think it should be fine.  I would split it and remove the bark and sapwood as soon as you can.  Make sure to seal the back if you take the bark and sapwood off.
I started out with nothin' and I still got most of it left

Offline Badly Bent

  • Member
  • Posts: 3,750
Re: Black locust log.
« Reply #5 on: March 13, 2017, 10:59:05 pm »
Good bet that its fine under those conditions, I'd split it asap as Beadman suggested though.
I ain't broke but I'm badly bent.

Offline bentstick54

  • Member
  • Posts: 770
Re: Black locust log.
« Reply #6 on: March 13, 2017, 11:25:53 pm »
I am also curious on how the grain runs on locust? The trunk and bark look as straight as you could ever hope to see. Should  I make a saw kerf down the center of one side and split with wedges from there, or split with wedges from end of the log so it follows the grain like Osage?

Offline osage outlaw

  • Member
  • Posts: 11,962
Re: Black locust log.
« Reply #7 on: March 13, 2017, 11:52:52 pm »
I would split it like osage.  From my experience it splits very similar.  If its straight grained and clean it should split easily.
I started out with nothin' and I still got most of it left

Offline George Tsoukalas

  • Member
  • Posts: 9,425
    • Traditional and Primitive Archers
Re: Black locust log.
« Reply #8 on: March 14, 2017, 12:21:32 am »
I do. Nice find. Jawge
Set Happens!
If you ain't breakin' you ain't makin!

Offline bentstick54

  • Member
  • Posts: 770
Re: Black locust log.
« Reply #9 on: March 14, 2017, 07:55:33 pm »
Thanks everyone. Hope to take possession this weekend and will get to splitting it and see where it goes from there.