« previous next »
Pages: [1]

Author Topic: Proceed as is?...  (Read 2096 times)

0 Members and 3 Guests are viewing this topic.

Offline Cloudfeather

  • Member
  • Posts: 431
Proceed as is?...
« on: October 14, 2016, 08:00:47 pm »
I'm working on this old piece of Osage. She has a bit of snake and is looking good so far. The only conundrum is this: there is some reflex off the handle into the upper limb and deflex off the handle into the lower limb.

Do I use a little heat and even it out, or just proceed as is? This picture is canted to show how straight the limbs are in relation to one another, it's just the handle section that has a little whoopty do in it. Lol

Any thoughts?
Logged

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,630
Re: Proceed as is?...
« Reply #1 on: October 14, 2016, 08:09:01 pm »
Just tiller it out. You won't know the difference.
Logged
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

Offline Badger

  • Member
  • Posts: 8,124
Re: Proceed as is?...
« Reply #2 on: October 14, 2016, 08:42:59 pm »
  Good looking bow!
Logged

Offline George Tsoukalas

  • Member
  • Posts: 9,425
    • Traditional and Primitive Archers
Re: Proceed as is?...
« Reply #3 on: October 14, 2016, 08:44:40 pm »
Just go with it and have fun. Jawge
Logged
Set Happens!
If you ain't breakin' you ain't makin!

Offline Cloudfeather

  • Member
  • Posts: 431
Re: Proceed as is?...
« Reply #4 on: October 14, 2016, 08:50:26 pm »
Quote from: Badger on October 14, 2016, 08:42:59 pm
  Good looking bow!

Thanks, Steve. Was originally going to get spoonbill skins, but I couldn't get them to lay flat or anything. Going to tiller it out and throw some rattlesnake skins on it instead.
Logged
Pages: [1]
« previous next »