« previous next »
Pages: [1]

Author Topic: Sealing after bark removal?  (Read 2034 times)

0 Members and 1 Guest are viewing this topic.

Offline finefirewood

  • Member
  • Posts: 43
Sealing after bark removal?
« on: November 27, 2013, 02:40:01 pm »
This may be a stupid question, but here goes.

Once you take the bark off the back of a stave and seal it, what do you do about the sealer once it is seasoned and you start working it? Scrape/sand it off? Nothing?

Thanks.

FF
Logged
Making ordinary wood into fine firewood one stick at a time!

Offline PEARL DRUMS

  • Member
  • Posts: 14,079
  • }}}--CK-->
Re: Sealing after bark removal?
« Reply #1 on: November 27, 2013, 03:11:29 pm »
Scrapers work fine for me. I rarely peel and seal my staves, so I rarely have sealer to take off.
Logged
Only when the last tree has died and the last river has been poisoned and the last fish has been caught will we realize we cannot eat money.

Offline osage outlaw

  • Member
  • Posts: 11,952
Re: Sealing after bark removal?
« Reply #2 on: November 27, 2013, 03:12:49 pm »
If I use shellac I don't usually do anything but the final sanding on the back.
Logged
I started out with nothin' and I still got most of it left

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,542
Re: Sealing after bark removal?
« Reply #3 on: November 27, 2013, 03:16:23 pm »
Like Clint I also use shellac. If you need to remove it a light sanding or a wipe down with alcohol will remove it.
Logged
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

Offline Slackbunny

  • Member
  • Posts: 866
Re: Sealing after bark removal?
« Reply #4 on: November 27, 2013, 03:16:53 pm »
I ignore it until I am doing final finishing. Then it normally sands and scrapes out pretty easy, especially on smooth backed bows. I use a lot of hophornbeam, and it can have quite a bit of ripples on the back, and that makes it trickier, but not too bad.

Most finishes have a product available for removing them, so if I was having a really hard time I might buy the appropriate remover and try that. But I've never had the need.

My favorite is shellac. It goes on quick and comes off pretty easy.
Logged

Offline George Tsoukalas

  • Member
  • Posts: 9,425
    • Traditional and Primitive Archers
Re: Sealing after bark removal?
« Reply #5 on: November 27, 2013, 04:44:55 pm »
It depends on the wood. For white woods sealing is optional. For black locust and osage, if still slightly green, it is essential.

In that case I remove the bark, sand with 100, 220, 400, and 600. Get it glossy smooth. Then I'll stain and or seal with spar urethane. Back is done. No scraping of shellac.

Jawge
Logged
Set Happens!
If you ain't breakin' you ain't makin!
Pages: [1]
« previous next »