Primitive Archer
Main Discussion Area => Bows => Topic started by: Huaco on August 08, 2008, 04:47:06 pm
-
I have found a source of Flat Sawn Red Oak. It is between 6' and 12' long. 6" and 12" wide and 1.25" thick. My question is... Is the thickness adequate to follow a ring if a suitable board is found, to make a "board bow" like is described in The Traditional Bowyers Bible?
The wood has already been dried...
-
You don't need to chase a ring unless you want to. Most board bows simply come from boards with few runouts, that is, the grain is straight over the length of the board.
If you wanted to chaes a ring, it would depend on how far into the board the outermost full ring were to run. 1.25" is pretty thick, the limbs would probably only run 1/2" thick at most. If you don't mind gluing on a handle piece it'd certainly be possible. And if you just find a good board with straight grain, 1.25" is probably enough for a handle.
-
Try to see if you can get any that is either Bias Cut or Edge /Rift Cut....these work best for me
-
Try to see if you can get any that is either Bias Cut or Edge /Rift Cut....these work best for me
What are these cuts?
-
Try to see if you can get any that is either Bias Cut or Edge /Rift Cut....these work best for me
What are these cuts?
[attachment deleted by admin]
-
All 3 cuts will work. From the top, regular log stave, plain sawn or flat sawn, bias cut or rift sawn, 1/4 sawn or edge ringed. If you choose a 1/4 sawn make sure the edge grain is completely parallel to the face of the board. I allow 2 run ups per limb for a 50-55# bend in the handle bow for the other cuts. No ring chasing needed . My site ha s a buildalong or 2. Jawge
http://mysite.verizon.net/georgeandjoni/archer.html