Primitive Archer
Main Discussion Area => Bows => Topic started by: stuckinthemud on February 02, 2024, 02:57:12 pm
-
I have a yew stave with 10mm thick sapwood. I’d like to reduce this by 5 or 6mm but that would take the stave to exactly the right thickness at the centre with absolutely no room for error. If I take 4mm then tiller it, can I reduce the draw weight by thinning out the sapwood?
-
Yes you can. I just did this actually on a recent yew build. I was aiming for 1:3 ratio sapwood to heartwood on finished bow and still got my target weight of 50. After I tillered bow and it was looking good as far as bend goes but was at 55 lbs. I didn’t want to remove any more of my heartwood to keep my ratios close so I went and removed just a bit more sapwood with sandpaper 150 grit and it got me to where I wanted. What I did to make sure I didn’t sand too much in one spot I put light pencil marks on the surface. I would sand those marks off and recheck it and repeat till done. I then covered my bow with a thin rawhide to protect the soft sapwood. Hope that helps. Good luck. Yew is magical stuff.
-
How much depth at the handle would you have if you remove the sapwood to your ideal thickness? 6mm sapwood is probably a little too thick for a 50lber, unless its low density yew.
What style of bow are you intending to build?