Primitive Archer
Main Discussion Area => Bows => Topic started by: sapling bowyer on January 19, 2016, 11:14:27 am
-
While I was working on my yew short bow which is 48 inches made from a small sapling, I noticed a crack on a knot on the back of the bow. That same limb takes set more than the other limb while floor tillering. I don't hear any sounds or any warnings when I bend it a couple of inches but I am concerned. Can I do anything to fix it. I have thought of filling the crack with wood dust and then putting plenty of glue on it. If you think it isn't a problem please say so I'm open to suggestions.
-
I don't like it that close to an edge and its size compared to the bows width. Glue wont hold it. This is the kind of bow I put rawhide on and never worry again. Some may say you never need a back on a self bow if its done right. I don't agree. They just haven't used a stave that needs a backing to be a reliable bow.
-
How do you put rawhide on it
-
With wood glue or hide glue. Search the term "Rawhide" on this site and start reading. Its not hard, but more than I want to type for the 32nd time, no offense whatsoever friend.
-
Ok. One thing I don't understand is that should I back the whole bow with rawhide or just make a patch on the crack?
-
You can go either way. Again, there are a few schools of thought. I'm a whole limb guy myself because I think wraps and patches are ugly. Not ineffective, just ugly.
-
Yup I'm with Pearlie... that's a big knot and the cuts in the sap would would give me the horrors.
There is an alternative which is to rasp out an long shallow scoop say 3-4" long and say 3/16" at the middle fading out at the tips and glue in a matching patch of clean sapwood.
Example here:-
http://bowyersdiary.blogspot.co.uk/2014/02/back-patch-and-tip-tidy.html (http://bowyersdiary.blogspot.co.uk/2014/02/back-patch-and-tip-tidy.html)
Del
-
Del, we never agree. Must be the stars are aligned chap!
-
My opinion is if that limb is already bending more then the other one the real damage might have already happened.
-
They both bend equally but the limb which has the knot takes set (temporarily) while the other doesn't
-
Ya fill that crack with dust and superglue and rawhide it. There's lots of YouTube videos as well showing the process. I'd smooth out those deep gouges too
-
I think you have great advice from above,,
consider putting a sinew patch down,, a 3 or 4 inch layer over the knot before you rawhide back it,, it would add just a bit more stability to that area,, I say that because the rasp marks are a little scary for me as well,,
the sinew patch would not show,, or be on the belly just on the back, and the rawhide back would add strength and make the bow aesthetically pleasing :)
also as Jawge would say,, leave that area a little stiffer in the final tiller,,
-
I agree with what's been said. A knot like that needs rawhide or sinew. But be careful next time and avoid those deep gouges in the back around the knot. Even if the knot were not there, those gouges would probably cause the bow to fail. The back needs to be smooth, even on woods like yew that can handle some violation of the back .