Primitive Archer
Main Discussion Area => Bows => Topic started by: campx on November 21, 2013, 05:12:59 pm
-
My buddy just dropped by with a present.
He cut two hazelnut trees down, pipe straight, no limbs, each piece 8 feet long. One is 8" diameter, the other 5". I plan on debarking and splitting them into staves, sealing the ends and drying them in my basement over the winter. -15Celsius here right now, so no outside drying.
Will hazelnut make a decent weight ELB, like in the 70pound range? It was grown at the Coast of BC, high humidity. Where I live is dry, semi-arid desert, super low RH.......thanks!
-
Hazel will make just about any type of bow, but requires a heat treated belly and may take a bit more set than you wish for.
-
I have some hazelnut that I'm planning on making into bigger bows like elb's. Not sure what dimensions for 70 lbs. but I think it would rival yew if treated properly.
-
Heat treat, round or trap the back and make absolutely sure there are no pin knots...it will crysal around them without much hesitation! If you do have any pins then wider is the way to go and NOT thicker.
Hazel is an impressive wood, i've made a few screamers from it but will not cut a tree if it has any pins in the bit I want to use.
-
Thanx for the replies. Plan on drawknifing he bark off tomorrow, and splitting ( after looking for a 180plus class mule deer anyways!)
-
Thanx for the replies. Plan on drawknifing he bark off tomorrow, and splitting ( after looking for a 180plus class mule deer anyways!)
IMO.
Don't use a drawknife to take off the bark, you may nick the wood, just leave the bark on or scrape it off... it's pretty thin bark.
It will probably pop off as the bow starts to really flex. Leaving it on is a good way to ensure you have a pristine back.
Del
-
Like Del says be careful of the back! I have had splinters raise on the back of two staves which had what I would call relatively minor blemishes! Spots that I wouldn't have given a seconds hesitation if it would have been vine maple! Just my experience! Dale
-
your opening post seems to indicate a concern with Relative humidity, and rightfully so this time of year. What is the temp in the basement? If the wood is too wet, you might want to slow down the drying at first