Primitive Archer
Main Discussion Area => Bows => Topic started by: youngbowyer on May 07, 2012, 11:18:58 pm
-
Hi, I have not been making a lot of bows lately because it is springtime and i like to go fishing in the spring ;D that's just the way things are. I hunt and bowbuild in the fall and winter but from march through july i fish and the cycle starts over gain 8) anyway, i've tried and failed to make a double loop bowstring and every time one loop falls out. i made a string jig but its way off, it makes my strings too short! Any advice and/or dimensions for a proper string jig.
Thanks,Tom.
-
You could always try an endless loop string. That might be easier to get the correct length. Or, you could make one loop and use a bowyers knot on the other end.
-
http://www.angelfire.com/sk/myplace/sparky15.html
this is not my site, but I've used the instructions on it in the past - was pleasantly surprised to see my old links still work....
D
-
yb i'll dig out the drawing for my string jig, works great, i also have a book on the flemish twist, you can have it if you pm me your address, Bub
-
I had a string jig I bought at a trad shoot in the '90's that worked great. When I got back into the sport last year, I couldn't find it so I downloaded a plan for building my own from the web. After I built it, I had the same problem as you when I first started. If your string is coming out too short, measure and adapt which nail you use to allow sufficient string to compensate. It worked for me. I built a few before I got it just right, but now it works like a charm!
-
Please explain "one loop falls out". Jawge
-
I have made several flemish twist string before but always with one loop and i tie a bowyers knot on the other end. However, if I use a bowyers knot on my recurve, the string will break after a few weeks. I have tried and failed to make a double looped string, I do what I normally do but I just make 2 loops instead. When tension is applied, one loop unravels. Not sure what i'm doing wrong.
-
I had that same trouble for a while and if its the same problem that I had, and heres the fix I found for it. After I twist up the first loop I take one of those paper clamps, the springy metal things that are shaped like a triangle with the two levers, and clamp it above the loop to keep it from unraveling while you twist the other. Then I twist up the other side and I found that when I do that it twists the main length of the string in the opposite direction of what it needs so before you take the clamp of holding the first loop you made twist the string in the direction that it needs to be, then you take the clamp off. Now you can pull on the loops of the string and hope it holds. This is what works for me. Clear as mud? And hope this helps
-
Mo-coon catcher's procedure should help you. Jawge