Primitive Archer
Main Discussion Area => Bows => Topic started by: toymaker on February 28, 2011, 01:35:30 am
-
I did a lot of driving today and had lots of time think about all kinds of stuff. One of the things I thought about was Quatersawn vs Flatwawn wood. They are basically 90 degrees from one another. Since quartersawn is best for backings I was thinking if a Flatsawn board is cut in half and glued together it would be wide enough for a backng. Then this new board could be sliced thin for multiple backers. This picture shows what I'm thinking. I was wondering if this would be strong enough. If I did this I would put the glue line dead center the length of the bow. If I did this would it work for a flat bow as well as an ELB? If this would work how about a trilamb setup with a dark wood pinstripe in the center?
The reason I'm thinking about this is I'm finding a lot of flatwsawn wood and almost zero quartersawn...
Red is cut lines, purple is glue lines.
(http://bazillionlights.com/Images/photobucket/Flat%20to%20Quarter600.jpg)
-
I can't see why that wouldn't work. A good glue line is supposedly stronger than wood. I think a better idea would be to find a flat sawn 2 x 10 and rip that up the way you describe. Even if it's not perfectly flat sawn, you will end up with plenty of nice bow blanks, and there will be about a 3 inch section in the middle that will be perfectly quatersawn, and ideal for backing strips.
Kinda like this:
(http://i162.photobucket.com/albums/t253/cbergerman/cut.jpg)
-
Makes sense I dont see why it wouldnt work as long as a good glue was used. I am curious if others have tried this?
-
that sounds like it should work, now i have something new to try ;D, well.... on top of all the other new stuff i find out each day
noel