Primitive Archer
Main Discussion Area => Bows => Topic started by: woody on March 29, 2007, 06:59:58 pm
-
Hi All,
I recently had a bow snap in two at mid-limb (the lower limb). I was surprised that this happened - for reasons other than the obvious. It was fairly well tillered, followed one growth ring on the back, and not real heavy in draw weight. I had it stored away in my closet, however, for several months without drawing it. I was wondering if the moister content may have had a chance to drop dangerously low. This did not seem likely to me since I put a hefty amount of finish on it (polyurethane, if I remember right). I thought that this finish would be somewhat impermeable. Is it possible for a bow to loose so much moisture in so short a period with so much finish on it?
Any thoughts would be much appreciated.
p.s. I would've posted some pics, but I was so ashamed that I immediately threw it in the trash. :-)
-
I always save broken bows. You can learn a lot from the break. Even though we seal our wood bows, the moisture content can and will change with changes in R/H. By sealing the bow, we are slowing this exchange. If your wood was dry and stored in a low humidity environment, it will loose moisture. Especially during the winter months.
...back to the break, did the back fail? at a knot or grain swirl? did the belly colapse? what kind of wood were you using? By studying breaks you will what went wrong and try not to do it again. A simple scratch or ding in the right place on the back of a wood bow can be fatal. Pat
-
I always put mine aside and come back a week later to inspect. I will repeat this as many times as it takes to figure it out. I had one for about 4 months. It wasn't until I made more bows with backing from the same board that I figured it out. The second and third bow failed also. It was a different spot on the limb, but after checking the grain on the backing. I discovered it was the exact same spot in the tree. Justin
-
I usually keep mine for about 30 min. some time a little less and then cook brats with them.
Got to have fire to.I have cooked a lot of brats over the years. ;D ;D Seriously I look them over
the best I can to see if it was me,sometime it is and sometime I just remember I am dealing with a piece of wood and you are never completely sure of what you got till you start bending it. :)
Pappy
-
Here are a few pics of the first osage bow(41"t/t) I ever made. It is from a board I bought from Dan Tice, Jay Massey's cousin, about 20 years ago. The grain was terribily violated but I could pull it to 20" with no problems and it would sling an arrow. I was showing it to one of the strapping young carpenters that was building my house and I told him to not draw it to more than 20" but before I knew it he had pulled it way back and it went boomyow!!! :o
I still look at the break today because it has tought me about breaks around grain violations. This bow broke right where it was supposed to. Pat
[attachment deleted by admin]
-
;D
Eeyup, Pat, they always seem to break RIGHT where they are supposed to!
-
Odds are it's moisture content was to low. Had four in a roll blow on me one winter....... I'm a little slow :-[! Several were hickory and one Osage. Other was a hickory backed persimmon. All bows were well tillered with thousands of shots through them. Got me a humidifier now! ;D-ART B
-
Hey that's great info everyone, thanks so much! Pat the break did occur just beneath a pronounced knot in the lower limb. I thought I had worked this area carefully so as to avoid any problems though. Oh well, these things happen.
-
It probably wasn't broke that bad until you smacked him for ruining it hey? lol
VB