« previous next »
Pages: [1]

Author Topic: Decreasing shaft spine  (Read 3600 times)

0 Members and 1 Guest are viewing this topic.

Offline agd68

  • Member
  • Posts: 306
Decreasing shaft spine
« on: July 17, 2008, 09:23:35 am »
When sanding a shaft to decrease the spine I assume you sand the shaft's full length,is this correct?
Logged
Happiness is..
A wet lab, dirty gun, and a cold beer after a day on the Marsh

Offline Pappy

  • Global Moderator
  • Member
  • Posts: 32,137
  • if you have to ask you wouldn't understand ,Tenn.
Re: Decreasing shaft spine
« Reply #1 on: July 17, 2008, 09:32:41 am »
A little more in the middle 2/3 and toward the nock end.
     Pappy
Logged
Clarksville,Tennessee
TwinOaks Bowhunters
Life is Good

Offline JackCrafty

  • Global Moderator
  • Member
  • Posts: 5,628
  • Sorry Officer, I was just gathering "materials".
Re: Decreasing shaft spine
« Reply #2 on: July 17, 2008, 11:05:18 am »
Sanding only part of the shaft is an advanced technique and requires a lot of skill.  IMO, sanding the shaft along the entire length is the safest bet.....especially if you're trying reduce the spine on lots of arrows.  Of course, if you've got the skill, using Pappy's advice will yield a superior arrow.
Logged
Any critter tastes good with enough butter on it.

Patrick Blank
Midland, Texas
Youtube: JackCrafty, Allergic Hobbit, Patrick Blank

Where's Rock? Public Waterways, Road Cuts, Landscape Supply, Knap-Ins.
How to Cook It?  200° for 24hrs then 275° to 500° for 4hrs (depending on type), Cool for 12hr
Pages: [1]
« previous next »