« previous next »
Pages: [1]

Author Topic: doing the twist vm  (Read 3191 times)

0 Members and 1 Guest are viewing this topic.

Offline Blacktail

  • Member
  • Posts: 1,432
doing the twist vm
« on: November 24, 2009, 12:52:16 am »
o.k. i am working on a vm stick..i got it too a low brace(first bracing) and i seen i had a twist on one limb...so,#1 WHAT CAUSES TWIST...#2 HOW WOULD YOU GET IT OUT...its mid limb out too the tip...thanks john
Logged

Offline Gordon

  • Member
  • Posts: 3,299
Re: doing the twist vm
« Reply #1 on: November 24, 2009, 01:29:49 am »
John, is the limb twisted while unbraced? If it is, then you can take it out with heat. If not, then you may have more wood on one edge of the limb than the other. In that case you have to take wood off from the other side to even things up.
Logged
Gordon

Offline Blacktail

  • Member
  • Posts: 1,432
Re: doing the twist vm
« Reply #2 on: November 24, 2009, 01:40:47 am »
all right gordon...when unbraced it looks fine..it kind of throw me for a loop...so,i will take more wood off the other side..thanks so much..i knew i had you around for a reason..john
Logged

Offline Gordon

  • Member
  • Posts: 3,299
Re: doing the twist vm
« Reply #3 on: November 24, 2009, 09:11:11 am »
John, the limb will twist toward the weak side. Take wood slowly off the strong side and excercise the limbs between each wood removal session.
Logged
Gordon

Offline Blacktail

  • Member
  • Posts: 1,432
Re: doing the twist vm
« Reply #4 on: November 24, 2009, 12:02:19 pm »
o.k. gordon...i can do that...i will let you know what happens..john
Logged

Offline Keenan

  • Member
  • Posts: 4,824
Re: doing the twist vm
« Reply #5 on: November 24, 2009, 03:12:21 pm »
Gordons advice is right on. ;)  Sometimes a propeller twist on both limbs will counter balance and equal out if the twist is in the stave.
Logged
Pages: [1]
« previous next »