Main Discussion Area > Bows
Splice bow project
Muskyman:
Couple pictures. The one billet has a little bit of wiggle about half way down. Should I worry about that or just have a little character to it.
bassman211:
Very good pics above Showing the right way to make a splice riser. Makes for a strong glue up. That being said I have made a series of Asian bows with bamboo floor boards with a simple long V splice riser glue up with AD 40. I add the handle to the back side of the bow, and glue, and wrap the Siyahs on. So far no failures. Their are bows made with V splice tips that are still doing fine, so I figured I would give the riser deal the same shot. It has worked so far though the bows are all 26 inch draw length, and draw weight is 40 to 45 lbs.
superdav95:
--- Quote from: Muskyman on June 17, 2024, 06:51:31 pm ---Couple pictures. The one billet has a little bit of wiggle about half way down. Should I worry about that or just have a little character to it.
--- End quote ---
I would get it glued up so that its good and straight and inline with each other then start working it down and follow your normal bow making practices. you can steam or dry heat correct the limbs just fine. just stay away from your handle section with the glue is all. ea40 is pretty good glue and quite durable. you may find that after glue up and getting it worked down that your tip alignment is pretty good and not bother with messing with it.
Muskyman:
Sounds like a good plan Dave. Thanks. Going to get all my ducks in a row before I start.
Eric Krewson:
White glue is not a mess to work with, a little on the back of the paper splice pattern, stick the pattern to the limb, cut out the splice, glue the splices and shape the handle section. After you shape the handle, any remnants of the splice pattern will be gone, the paper scrapes off very easily, much like shellac.
The best thing about white glue is you can slide the pattern around on the back of your limb while it is still wet with glue to get a perfect alignment with centerline. With contact cement you only get one shot at getting things right.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version