Main Discussion Area > Arrows
rose shafts - how?
Pat B:
Not at all. A sinew or thread wrap is all you need to hold it together.
stuckinthemud:
Fab
stuckinthemud:
Right, so, the shafts have been drying few weeks, been working them straight, though they were pretty good to start with. I need them for target shooting. Before I cut to length, any recommendations on diameter for 26” shaft and draw weight between 30 and 40lb?
Pat B:
Start out using the small end and make them 30" long and give that a try. If too light of spine cut 1" off the point end and try again, etc.
Navigation
[0] Message Index
[*] Previous page
Go to full version