« previous next »
Pages: [1]

Author Topic: Opinion sought on Ipe flat d bow  (Read 959 times)

0 Members and 1 Guest are viewing this topic.

Offline snedeker

  • Member
  • Posts: 907
Opinion sought on Ipe flat d bow
« on: August 29, 2020, 10:40:16 am »
At a request, I am planning a long bamboo backed Ipe flat bend through handle sort of eastern Woodland design, 65# at 28"   I figure 71" ntn and 1&1/8" wide

Ipe slat I have is 9/16" think.   Thick enough for design?
Dve
Logged

bownarra

  • Guest
Re: Opinion sought on Ipe flat d bow
« Reply #1 on: August 29, 2020, 12:13:46 pm »
Yup certainly is :)
Taper rate of 0.009" cut into the ipe before glue-up will get you close to tillered.
Logged

bownarra

  • Guest
Re: Opinion sought on Ipe flat d bow
« Reply #2 on: August 29, 2020, 12:14:26 pm »
You probably want 7/8ths thickness in the handle to start off.
Logged

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,633
Re: Opinion sought on Ipe flat d bow
« Reply #3 on: August 29, 2020, 03:53:03 pm »
Welcome back, Dave Glad to see you are still at it.
You could add a power lam between the ipe and boo at the handle if 9/16" isn't enough at the handle. If you are wanting a stiff handle flat bow that may be what you'll have to do.
Logged
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

Offline snedeker

  • Member
  • Posts: 907
Re: Opinion sought on Ipe flat d bow
« Reply #4 on: August 29, 2020, 08:21:42 pm »
 Thanks.   Hi Pat.  I always visit once in a while.  I figured a thin tapered central lam would be needed.  Just wanted to hear it.
Dave
Logged
Pages: [1]
« previous next »