« previous next »
Pages: [1]

Author Topic: Need some help with my pressure flaker  (Read 2773 times)

0 Members and 1 Guest are viewing this topic.

Offline Deerhunter21

  • Member
  • Posts: 2,261
  • What do you despise? By this are you truly known.
Need some help with my pressure flaker
« on: June 27, 2020, 11:59:55 am »
It’s getting too short and I need to take it out and put a new one in. Any idea how I can do this?
Logged
Life before death. Strength before weakness. Journey before destination.

Offline Deerhunter21

  • Member
  • Posts: 2,261
  • What do you despise? By this are you truly known.
Re: Need some help with my pressure flaker
« Reply #1 on: June 27, 2020, 12:00:47 pm »
Pic
Logged
Life before death. Strength before weakness. Journey before destination.

Offline Deerhunter21

  • Member
  • Posts: 2,261
  • What do you despise? By this are you truly known.
Re: Need some help with my pressure flaker
« Reply #2 on: June 27, 2020, 01:43:34 pm »
never mind i got it done.
Logged
Life before death. Strength before weakness. Journey before destination.

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,613
Re: Need some help with my pressure flaker
« Reply #3 on: June 28, 2020, 11:43:24 am »
I was going to suggest grabbing it with a pair of pliers and pull.
Logged
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

gutpile

  • Guest
Re: Need some help with my pressure flaker
« Reply #4 on: June 29, 2020, 01:35:07 pm »
I just grind the handle a tad to expose more copper... I also use a hammer to flatten to a point also.. that way when it needs touch up I can hammer most of it back to point and touch up with file... Gut
Logged

Offline mullet

  • Global Moderator
  • Member
  • Posts: 22,911
  • Eddie Parker
Re: Need some help with my pressure flaker
« Reply #5 on: June 30, 2020, 05:48:12 am »
If you glue it in with epoxy an easy way to get epoxy to release is to put it in the freezer overnight. most of us drill a small hole down to the copper and screw a 1/4" "elen" screw in. That way you can remove easy or adjust it when you need to.
Logged
Lakeland, Florida
 If you have to pull the trigger, is it really archery?

Offline Deerhunter21

  • Member
  • Posts: 2,261
  • What do you despise? By this are you truly known.
Re: Need some help with my pressure flaker
« Reply #6 on: July 03, 2020, 12:18:46 pm »
i used heat to warm the epoxy up and vinigar to soften the epoxy on the top up then just pulled!
Logged
Life before death. Strength before weakness. Journey before destination.
Pages: [1]
« previous next »