Author Topic: Am I thinking correctly  (Read 2831 times)

0 Members and 1 Guest are viewing this topic.

Offline stuckinthemud

  • Member
  • Posts: 2,355
    • avenue woodcarving
Re: Am I thinking correctly
« Reply #15 on: April 10, 2020, 11:25:17 am »
I 've got head scratching and beard stroking off to a T, I'm now working on frowning slightly

Offline Hawkdancer

  • Member
  • Posts: 5,040
Re: Am I thinking correctly
« Reply #16 on: April 10, 2020, 11:45:37 am »
Remember, it is very important that you have only a very slight quizzical frown!  That Makes the AHA! much more effective and it is easier to break out laughing hysterically!  Folks may think you are a bit wacko, however!
Hawkdancer
Life is far too serious to be taken that way!
Jerry

Offline stuckinthemud

  • Member
  • Posts: 2,355
    • avenue woodcarving
Re: Am I thinking correctly
« Reply #17 on: April 10, 2020, 11:51:14 am »
Hmmm, since I should no longer touch my face due to the virus, I have extra time to master the quizzical frown, I think I will try to develop a puzzled " mmmm". Wonder if the Ministry will give me a research grant.  ;D

Online bjrogg

  • Member
  • Posts: 11,025
  • Cedar Pond
Re: Am I thinking correctly
« Reply #18 on: April 10, 2020, 12:14:06 pm »
I think everything is becoming clearer already.
Bjrogg
A hot cup of coffee and a beautiful sunrise

Offline Swampman

  • Member
  • Posts: 1,046
  • Primitive Archer subscription number PM109299
Re: Am I thinking correctly
« Reply #19 on: April 10, 2020, 04:11:38 pm »
This entire thread is causing me to frown slightly and scratch my head! 

Offline stuckinthemud

  • Member
  • Posts: 2,355
    • avenue woodcarving
Re: Am I thinking correctly
« Reply #20 on: April 11, 2020, 11:37:47 am »
I stripped the bark and have 2 clusters of pin knots 40 inches apart,  not big enough to worry over. Moisture content wasn't as low as I thought though,  the split has grown to over 8 inches and stops just shy of one of the two knots .  At mid-point, the diameter is 3", the arc across the crown is 5"

« Last Edit: April 11, 2020, 12:28:36 pm by stuckinthemud »

Offline stuckinthemud

  • Member
  • Posts: 2,355
    • avenue woodcarving
Re: Am I thinking correctly
« Reply #21 on: April 12, 2020, 11:38:07 am »
I took the plunge and opened the split up. Once I got the split run off one end I literally pulled the stave in half, guess the damage went a lot deeper than I thought.  Ended up with one stave slightly wider than the other but both are still useable.  I'll clean both up and work out where to go from there.