« previous next »
Pages: [1] 2

Author Topic: crack in back  (Read 2583 times)

0 Members and 1 Guest are viewing this topic.

Offline razorsharptokill

  • Member
  • Posts: 170
crack in back
« on: January 10, 2020, 04:04:39 pm »
Got through the sapwood and found this. Fatal? Could shorten the bow and thin the limb and eliminate the crack. It would end up being a teen/young adult bow but that is fine too.
Logged
Jim Richards
Veteran

USMC 84-88
Oklahoma Army National Guard 88-89
USMCR 89-96 Desert Storm
Oklahoma Air National Guard 2002- present. Operation Iraqi Freedom 2005(Qatar) and 2007(Iraq)
Operation New Dawn Iraq 2011
Operation Enduring Freedom 2018 Afghanstan

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,609
Re: crack in back
« Reply #1 on: January 10, 2020, 05:14:00 pm »
Jim, follow the grain the check is on. If it stays in the limb and doesn't run off you should be OK.
Logged
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

Offline bradsmith2010

  • Member
  • Posts: 5,187
Re: crack in back
« Reply #2 on: January 10, 2020, 07:24:14 pm »
Not fatal )P(
Logged

Offline SLIMBOB

  • Member
  • Posts: 3,759
  • Deplorable Slim
Re: crack in back
« Reply #3 on: January 10, 2020, 07:28:51 pm »
My first thought is can you eliminate the crack?  Is it wide enough?  If so, that’s a possibility. If not, so long as it does not travel off the edge you could be fine like it is.
Logged
Liberty, In God We Trust, E Pluribus Unum.  Distinctly American Values.

Offline bjrogg

  • Member
  • Posts: 10,987
  • Cedar Pond
Re: crack in back
« Reply #4 on: January 10, 2020, 08:01:30 pm »
Quote from: SLIMBOB on January 10, 2020, 07:28:51 pm
My first thought is can you eliminate the crack?  Is it wide enough?  If so, that’s a possibility. If not, so long as it does not travel off the edge you could be fine like it is.

This is my thought to.
Bjrogg
Logged
A hot cup of coffee and a beautiful sunrise

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,609
Re: crack in back
« Reply #5 on: January 10, 2020, 09:15:42 pm »
I would add thin super glue to the checks.
Logged
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

Offline Deerhunter21

  • Member
  • Posts: 2,261
  • What do you despise? By this are you truly known.
Re: crack in back
« Reply #6 on: January 10, 2020, 10:17:47 pm »
If your worried do a rawhide bandaid and superglue. otherwise, listen to these guys!
Logged
Life before death. Strength before weakness. Journey before destination.

Offline bradsmith2010

  • Member
  • Posts: 5,187
Re: crack in back
« Reply #7 on: January 10, 2020, 11:04:04 pm »
Rawhide sounds good, probably not needed, but I like it
Logged

bownarra

  • Guest
Re: crack in back
« Reply #8 on: January 11, 2020, 01:56:32 am »
What caused that check? Tension in the wood as it dried too fast. Is all that tension gone? Could it open up when shooting?
Sure you could try and fill it with CA but personally I'd remove it. Osage can do 80# @ 1 inch wide.
Logged

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,609
Re: crack in back
« Reply #9 on: January 11, 2020, 07:23:43 am »
Checks are generally caused by drying, as the wood dries it shrinks and if not prevented by sealing can pull the wood apart along a grain. I would seal the back and if you expose another back ring later seal it again and keep it sealed until final sanding and adding the finish. Shellac works well for the sealing because it can be easily removed when you want it gone.
Logged
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

Offline George Tsoukalas

  • Member
  • Posts: 9,425
    • Traditional and Primitive Archers
Re: crack in back
« Reply #10 on: January 11, 2020, 07:47:40 am »
 I assume it is osage. Carefully, drawknife it away. It looks like it is beginning to run off the edge. That is what I would do. Jawge
Logged
Set Happens!
If you ain't breakin' you ain't makin!

Offline Eric Krewson

  • Member
  • Posts: 5,412
Re: crack in back
« Reply #11 on: January 11, 2020, 08:54:18 am »
Are there any darker streaks on the belly? looks like a wind shake to me.
Logged

Offline razorsharptokill

  • Member
  • Posts: 170
Re: crack in back
« Reply #12 on: January 11, 2020, 11:28:38 am »
It is Osage and the guy I got the stave from removed the bark but didn't seal the back. Probably 10 years ago. It is probably about an inch at the narrowest point. I am still chasing the ring  on this stave.
Logged
Jim Richards
Veteran

USMC 84-88
Oklahoma Army National Guard 88-89
USMCR 89-96 Desert Storm
Oklahoma Air National Guard 2002- present. Operation Iraqi Freedom 2005(Qatar) and 2007(Iraq)
Operation New Dawn Iraq 2011
Operation Enduring Freedom 2018 Afghanstan

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,609
Re: crack in back
« Reply #13 on: January 11, 2020, 12:47:38 pm »
Even at 10 years the stave can check when new wood is revealed so seal it as you expose a new back ring.
Logged
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

Offline bradsmith2010

  • Member
  • Posts: 5,187
Re: crack in back
« Reply #14 on: January 11, 2020, 02:08:09 pm »
I still feel very optimistic that it will make a bow,, ,, however you decide to resolve the issue of the check,,
osage is amazing stuff,, if it was mine I would leave it wide and rawhide back,, but taking the check out would make just as good a bow,, pretty much your call,,
« Last Edit: January 11, 2020, 03:10:20 pm by bradsmith2010 »
Logged
Pages: [1] 2
« previous next »