« previous next »
Pages: [1]

Author Topic: How long to steam.  (Read 1435 times)

0 Members and 1 Guest are viewing this topic.

Offline IrishJay

  • Member
  • Posts: 442
How long to steam.
« on: October 06, 2019, 01:22:41 pm »
I finally got around to building myself a stave steamer so I can steam a whole stave in one shot rather than using a heat gun on small sections wrapped in wet rags and tin foil.

My first victim is going to be a piece of hard maple that I'm having trouble getting the bark off of. So my question is, how long should I steam it to loosen the bark? How long when I'm ready to bend it?
Logged
"The best camouflage pattern is called, 'Sit down and be quiet!' Your grandpa hunted deer in a red plaid coat, think about that for a second." - Fred Bear

Offline Del the cat

  • Member
  • Posts: 8,322
    • Derek Hutchison Native Wood Self Bows
Re: How long to steam.
« Reply #1 on: October 06, 2019, 02:06:51 pm »
Twice as long as you think  ;)
They reckon a rule of thumb is an hour per inch of thickness.
Del
Logged
Health warning, these posts may contain traces of nut.

Offline IrishJay

  • Member
  • Posts: 442
Re: How long to steam.
« Reply #2 on: October 06, 2019, 02:18:53 pm »
Thanks Del. My plan is to steam it, get clamped down to my full length form, and then set it aside form and all to cure for a few months.
Logged
"The best camouflage pattern is called, 'Sit down and be quiet!' Your grandpa hunted deer in a red plaid coat, think about that for a second." - Fred Bear
Pages: [1]
« previous next »