« previous next »
Pages: [1]

Author Topic: Stripping wax and oil before adding Snake skin backing?  (Read 1581 times)

0 Members and 1 Guest are viewing this topic.

Offline apg

  • Member
  • Posts: 76
Stripping wax and oil before adding Snake skin backing?
« on: February 12, 2018, 08:07:45 pm »
Hi all,
I’m going to be adding a snake skin backing to my bow (an Osage flat bow), and since I’ve sealed it with tung oil (6 coats) and wax (1 coat) I’m wondering if I need to sand it back before I glue the snake skin down?
And if I do, does it need to be a really thorough sand or just some 000 steel wool?
Thanks!
Ash
Logged

Offline JWMALONE

  • Member
  • Posts: 450
Re: Stripping wax and oil before adding Snake skin backing?
« Reply #1 on: February 12, 2018, 08:34:55 pm »
If I were you id sand it back down. What type of Tung oil did you use? Its not all pure tung oil unfortunately. What type of glue do you intend to use?
Logged
Red Oak its the gateway wood!

Offline PatM

  • Member
  • Posts: 6,737
Re: Stripping wax and oil before adding Snake skin backing?
« Reply #2 on: February 12, 2018, 08:47:50 pm »
Best to get it really clean. I'd use some sort of solvent and then a strong soap scrub followed by a light sanding.
Logged

Offline Mesophilic

  • Member
  • Posts: 876
Re: Stripping wax and oil before adding Snake skin backing?
« Reply #3 on: February 12, 2018, 08:54:14 pm »
This could be just the excuse you need to make another one.  You know you want to anyway ;D
Logged
Trying is the first step to failure
-Homer Simpson-

Offline bjrogg

  • Member
  • Posts: 10,987
  • Cedar Pond
Re: Stripping wax and oil before adding Snake skin backing?
« Reply #4 on: February 12, 2018, 08:57:09 pm »
I've scuffed tru oil with steel wool on HHB and glued on with TBII with good luck. I've never used wax or tung oil before but would do like Pat said. I tried a test with scrap wood and scrap skin before I tried bow with tru oil.
Bjrogg
Logged
A hot cup of coffee and a beautiful sunrise
Pages: [1]
« previous next »