« previous next »
Pages: [1]

Author Topic: Unibond 800  (Read 1711 times)

0 Members and 1 Guest are viewing this topic.

Offline Markus

  • Member
  • Posts: 183
Unibond 800
« on: May 10, 2016, 08:44:32 am »
When laminating with Unibond 800, do you use a lot of clamping pressure or? Also what grit do you use to rough up the gluing surfaces?
Thanks Markus.
Logged

Offline PEARL DRUMS

  • Member
  • Posts: 14,079
  • }}}--CK-->
Re: Unibond 800
« Reply #1 on: May 10, 2016, 09:14:10 am »
I use "enough" pressure, but not much. You can get dry joints if you squeeze too tight. That epoxy requires a toothed surface, sanding isn't enough. I use a 4" piece of hacksaw blade to scratch up my surfaces. I have had zero glue failures using it. Maybe a few bowyer failures, but never glue.
Logged
Only when the last tree has died and the last river has been poisoned and the last fish has been caught will we realize we cannot eat money.

Offline Markus

  • Member
  • Posts: 183
Re: Unibond 800
« Reply #2 on: May 10, 2016, 03:22:54 pm »
Pearl Drums, just to make sure, you are saying epoxy. Is it Unibond 800 you mean?
Logged

Offline PatM

  • Member
  • Posts: 6,737
Re: Unibond 800
« Reply #3 on: May 10, 2016, 04:50:45 pm »
People do seem to generically call Unibond or Urac  "epoxy". even though it chemically is not.
Logged
Pages: [1]
« previous next »