« previous next »
Pages: [1]

Author Topic: solution for edge break  (Read 4291 times)

0 Members and 1 Guest are viewing this topic.

Offline iowabow

  • member
  • Member
  • Posts: 4,722
solution for edge break
« on: November 08, 2015, 03:26:16 pm »
Here is the wide preform with diagonal flakes and no over shot edge. My solution was to create small directional flute channels of the larger pressure flakes to travel into. This will allow the finished point to be nice and thin with diagonal flake scars.
Logged
(:::.) The ABO path is a new frontier to the past!

Offline Hummingbird Point

  • Member
  • Posts: 147
Re: solution for edge break
« Reply #1 on: November 08, 2015, 04:04:23 pm »
I am sorry I am currently pre-occupied trying to figure other stuff and haven't commented on your work.  It is really cool, keep at it.  At some point in the future I will be bugging you to learn more about how you are doing this stuff, but right now my poor little brain can only handle so much.

Keith 
Logged

Offline iowabow

  • member
  • Member
  • Posts: 4,722
Re: solution for edge break
« Reply #2 on: November 08, 2015, 04:28:13 pm »
That's cool just thought I would share this little discovery.
Logged
(:::.) The ABO path is a new frontier to the past!

Offline nclonghunter

  • Member
  • Posts: 1,779
Re: solution for edge break
« Reply #3 on: November 08, 2015, 04:38:26 pm »
Oh Heck yes, those are dandy
Logged
There are no bad knappers, only bad flakes
Pages: [1]
« previous next »