« previous next »
Pages: [1]

Author Topic: splicing a power lam?  (Read 1145 times)

0 Members and 1 Guest are viewing this topic.

Offline Aaron H

  • Member
  • Posts: 3,437
splicing a power lam?
« on: October 26, 2015, 11:05:09 am »
Would I be ok to splice together my power lam with say a z splice, or would it be smarter to keep it one piece?
Logged

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,609
Re: splicing a power lam?
« Reply #1 on: October 26, 2015, 11:43:38 am »
All a power lam does is stiffens the handle area to keep it from bending. A "Z" splice should be adequate to do this.
Logged
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

Offline Aaron H

  • Member
  • Posts: 3,437
Re: splicing a power lam?
« Reply #2 on: October 26, 2015, 12:34:11 pm »
That's kinda what I figured.  Thanks Pat
Logged

Offline Badger

  • Member
  • Posts: 8,124
Re: splicing a power lam?
« Reply #3 on: October 26, 2015, 12:55:06 pm »
I sometimes just cut a 45 degree angle on internal splices like lams and then butt them up. Doesn't seem to be much stress on the joint
Logged

Offline lebhuntfish

  • Member
  • Posts: 3,823
  • If the wood will bend, I'll make it beautiful!
Re: splicing a power lam?
« Reply #4 on: October 26, 2015, 02:03:27 pm »
Sleek and I did one a while back that pretty much just had a scarf joint like Badger said. Ours was on the core wood. It didn't hurt a thing!
Patrick
Logged
Once an Eagle Scout, always an Eagle Scout!

Missouri, where all the best wood is! Well maybe not the straightest!

Building a bow has been the most rewarding, peaceful, and frustrating things I have ever made with my own two hands!
Pages: [1]
« previous next »