« previous next »
Pages: [1]

Author Topic: Drying Osage question  (Read 1870 times)

0 Members and 1 Guest are viewing this topic.

Offline BrokenArrow

  • Member
  • Posts: 168
Drying Osage question
« on: April 01, 2015, 02:43:06 pm »
I am drying some osage and noted that when the back does not have sapwood and is not sealed that slight cracks form.
Is it ok to have lateral cracks if the ring you intend to follow is a couple below the crack or does the crack usually go down through more than one ring?
Logged

gutpile

  • Guest
Re: Drying Osage question
« Reply #1 on: April 01, 2015, 02:47:48 pm »
it can go down more than one or two or three all depends..I would seal back and ends just to prevent it though...gut
Logged

Offline docmann

  • Member
  • Posts: 56
  • Proud Member Oklahoma Selfbow Society
Re: Drying Osage question
« Reply #2 on: April 01, 2015, 03:11:35 pm »
Ditto Gutpile's comments. Without sealing the ends and back it's a real crap shoot. You've already done the hard work.
Logged

Offline PEARL DRUMS

  • Member
  • Posts: 14,079
  • }}}--CK-->
Re: Drying Osage question
« Reply #3 on: April 01, 2015, 03:17:38 pm »
Where you store them is very important. You can seal backs and ends and still get checks all over the backs. A slow, gradual dry is best.
Logged
Only when the last tree has died and the last river has been poisoned and the last fish has been caught will we realize we cannot eat money.

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,609
Re: Drying Osage question
« Reply #4 on: April 01, 2015, 05:38:06 pm »
I seal the back of any stave I expose a new back. I've had 10 year old osage staves check that had newly exposed backs. I use spray shellac as sealer and it takes about 10 seconds to seal the back of almost any size stave. New3ly exposed ends always get sealed too.
Logged
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

Offline Cloudfeather

  • Member
  • Posts: 431
Re: Drying Osage question
« Reply #5 on: April 01, 2015, 07:00:23 pm »
What PD said. I had a huge haul of 60+ year old, 12+ inch diameter logs that had been in a field for 60 years, then in a barn for 2 years. After cleaning the inch or so of crap off of the staves and sealing the backs, I still had a couple develop checks. The only way I could prevent it was to use a ridiculous amount of poly or use some TBIII.

Take the extra 2 minutes and pennies it costs to seal it properly, otherwise you risk having to chase rings again, or worse, possibly ruining the stave.
Logged
Pages: [1]
« previous next »