Author Topic: Heat-treating a white oak board over a stove flame (no heat-gun)- How and When?  (Read 1900 times)

0 Members and 1 Guest are viewing this topic.

Offline arachnid

  • Member
  • Posts: 517
Well, The title says it all... ;D

Dor

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,609
At the same time you would by any other method.  ;)
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

Offline arachnid

  • Member
  • Posts: 517
Ok, the main question was how do I do it without scorchong the wood or causing the heat to spread to the back.
 Any jig needed?
 How far from the flame should I place the bow?
Big flame of small?
Is it really a 1/2 hour per limb?

I guess the title didn't said it all... :-\

Offline bubbles

  • Member
  • Posts: 932
  • PM110769
I did it a few times before i had a heat gun. Again, its, very similar to the other methods. Figure out a way to suspend the bow above the flame ( 3~5 inches with your flame on LOW, as low as you can make it) this could  be your arm, or if you get tired, some blocks of wood, etc.  Figure out a way to monitor the progress. I sat on the floor right beside the stove and read a book. Just need to look up to see how it was toasting. Then slide along as you see necessary. Stove requires more vigilance than a heat gun, but works just the same.

Offline arachnid

  • Member
  • Posts: 517
Thanks Bubbles.