« previous next »
Pages: [1]

Author Topic: Recurve string alignment  (Read 1369 times)

0 Members and 1 Guest are viewing this topic.

Offline DC

  • Member
  • Posts: 10,396
Recurve string alignment
« on: February 22, 2015, 02:45:29 pm »
When do I do the string alignment heat adjustments? I'm at 22" draw length, looking for 27. The string is about 1/4" out on one recurve. Should I do an adjustment now or wait until I'm closer to finished.
Logged

Offline wizardgoat

  • Member
  • Posts: 2,397
Re: Recurve string alignment
« Reply #1 on: February 22, 2015, 04:03:28 pm »
1/4" ain't bad! I'd do it sooner than later. Can you narrow your tips to try and get your 1/4" without heat?
Logged

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,633
Re: Recurve string alignment
« Reply #2 on: February 22, 2015, 04:14:02 pm »
I'd do it now.
Logged
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

Offline DC

  • Member
  • Posts: 10,396
Re: Recurve string alignment
« Reply #3 on: February 22, 2015, 04:20:46 pm »
Quote from: wizardgoat on February 22, 2015, 04:03:28 pm
1/4" ain't bad! I'd do it sooner than later. Can you narrow your tips to try and get your 1/4" without heat?
I could narrow the tips a bit but there is a little bit of twist in the recurve and I thought I would take that out at the same time. I'm planning on narrowing the tips a bit but I thought I would get it straight and aligned first. Anyway I got two answers and both say do it now so out to the shop I go.
Thanks
Don
Logged
Pages: [1]
« previous next »