« previous next »
Pages: [1]

Author Topic: Rawhide backing on a hole  (Read 1511 times)

0 Members and 1 Guest are viewing this topic.

Offline alwayslookin

  • Member
  • Posts: 350
Rawhide backing on a hole
« on: February 22, 2015, 01:14:34 pm »
Never had to put a backing on a stave with a hole. Do I put it over the hoke and leave it one piece? Or should I cut the hole out when I put it on? It seems to me like making a hole in the backing would help it sit more flush on the stave but I've never done this so looking for some ideas if anyone has dealt with this before.
Logged
In all your ways acknowledge  him and he will make your paths straight.

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,633
Re: Rawhide backing on a hole
« Reply #1 on: February 22, 2015, 01:48:21 pm »
I usually cut an "X" centered on the hole and fold the points down into the hole. The raw hide will conform to the contours with a little help.
Logged
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

Offline PEARL DRUMS

  • Member
  • Posts: 14,079
  • }}}--CK-->
Re: Rawhide backing on a hole
« Reply #2 on: February 22, 2015, 01:49:51 pm »
I use the point of an exacto knife and just cut right around the inside of the hole.
Logged
Only when the last tree has died and the last river has been poisoned and the last fish has been caught will we realize we cannot eat money.

Offline alwayslookin

  • Member
  • Posts: 350
Re: Rawhide backing on a hole
« Reply #3 on: February 22, 2015, 02:34:31 pm »
OK those were the two ideas it seemed to me that would work best. I'm using titebond 3 any one have any objections to that with rawhide?
Logged
In all your ways acknowledge  him and he will make your paths straight.
Pages: [1]
« previous next »