my grandfather in his later years when he was less mobile started doing a fair amount of wood carving. When he passed I inherited all his tools. Once in a while I go through and grab a sharp knife for doing some inlays or sharp chisel for what not but I found something in there that interest me. Very simple idea just a piece of wood notched out with a 1 inch wide sanding belts screwed to each side for easy paper removal. This is an extremely efficient way to sand bow limbs. you could either buy 1 inch rolls or buy 1 by 42 belts and cut them. works extremely well for getting in the radius of the riser or shaping out handles. if you're sick of holding sandpaper give this a try. this may not be new to most of you but I figured it couldn't hurt to share with some
