« previous next »
Pages: [1]

Author Topic: Laminations done with Smooth On EA 40 and steambending  (Read 1945 times)

0 Members and 1 Guest are viewing this topic.

Offline BrokenArrow

  • Member
  • Posts: 169
Laminations done with Smooth On EA 40 and steambending
« on: October 27, 2014, 03:58:20 pm »
I finished a hickory back jatoba core lamination done with Smooth On EA 40 Epoxy which was mixed 2 parts A to 1 part B.
This should have made the epoxy safe to 217 degrees F as steam is 211 degrees F.
I steamed it for 2 hours and it has held together fine :)
But as I was warned the epoxy could not hold the wood at the bend it was set at as it returned to almost straight position :(
So the experiement both succeeded and failed and I will not do that again.
If you want epoxy to hold a bend it must be done when the epoxy is drying.
Logged

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,667
Re: Laminations done with Smooth On EA 40 and steambending
« Reply #1 on: October 27, 2014, 05:13:26 pm »
You are fighting the glue line. You should get your profile shape for the belly and backing before glue up.
Logged
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

mikekeswick

  • Guest
Re: Laminations done with Smooth On EA 40 and steambending
« Reply #2 on: October 28, 2014, 03:33:05 am »
Yes the glueline won't plastify with the heat only the wood.
Logged
Pages: [1]
« previous next »