« previous next »
Pages: [1]

Author Topic: trilam bow  (Read 2361 times)

0 Members and 1 Guest are viewing this topic.

Offline smoky#1

  • Member
  • Posts: 98
  • Clayton Porter
trilam bow
« on: September 19, 2014, 08:59:48 am »
I think that this bow is almost finished, It is 60 inches ntn, made from Oak, Cedar, and Hackberry. it has some knots.
Logged
smoky, Bassett NE

blackhawk

  • Guest
Re: trilam bow
« Reply #1 on: September 19, 2014, 09:11:04 am »
Good effort.... But you have a hinge in the upper limb...its pretty apparent, and even can easily be seen by how much thinner it is there versus before and after...also you can see it took more set there as well unbraced..bottom limb looks OK tho....
Logged

Offline smoky#1

  • Member
  • Posts: 98
  • Clayton Porter
Re: trilam bow
« Reply #2 on: September 19, 2014, 09:27:08 am »
The hinge is where the knot in the fifth photo is, was wondering what i could do to finish the bow with a little less of a hinge
Logged
smoky, Bassett NE

Offline PEARL DRUMS

  • Member
  • Posts: 14,079
  • }}}--CK-->
Re: trilam bow
« Reply #3 on: September 19, 2014, 09:37:24 am »
Smoky you need to start with better materials to end with a better bow. That piece of oak with that knot should have been looked past. Its going to blow up on you my friend. Very good effort, just choose better materials next time.
« Last Edit: September 19, 2014, 09:45:17 am by PEARL DRUMS »
Logged
Only when the last tree has died and the last river has been poisoned and the last fish has been caught will we realize we cannot eat money.

Offline smoky#1

  • Member
  • Posts: 98
  • Clayton Porter
Re: trilam bow
« Reply #4 on: September 19, 2014, 04:03:31 pm »
Okay, i will do that on my next trilam
Logged
smoky, Bassett NE

Offline Marc St Louis

  • Administrator
  • Member
  • Posts: 7,877
  • Keep it flexible
    • Marc's Bows and Arrows
Re: trilam bow
« Reply #5 on: September 19, 2014, 07:51:35 pm »
You could soften the outer limb past the knot.  That would take some stress off the knot area and make the bow last a bit longer
Logged
Home of heat-treating, Corbeil, On.  Canada

Marc@Ironwoodbowyer.com

Offline smoky#1

  • Member
  • Posts: 98
  • Clayton Porter
Re: trilam bow
« Reply #6 on: September 20, 2014, 10:55:40 am »
I'll do that!
Logged
smoky, Bassett NE
Pages: [1]
« previous next »