« previous next »
Pages: [1]

Author Topic: Bow backing  (Read 891 times)

0 Members and 1 Guest are viewing this topic.

Offline Jjpso

  • Member
  • Posts: 101
Bow backing
« on: May 06, 2014, 06:07:11 am »
Good morning people.

I am doing a red or white oak board bow - not sure wich oak is.
It was planned to be a 68" tip to tip pyramid design, with a non bendig handle, but due to a mistake i made, i had to get it just a hair over 63", so it will end up 61" NTN.
The maximum width at fades is 2", tappering down to 1/2" tips.
My question is, since i had to take it to 63", and i was planning to get  45/50# at 28", should i back it?
If so, with what? Rawhide? Silk? Fiberglass tape?
Or do you think 63" is enough and i dont need backing?

Thanks sinto advance

Joao from Portugal
« Last Edit: May 06, 2014, 06:11:01 am by Jjpso »
Logged

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,613
Re: Bow backing
« Reply #1 on: May 06, 2014, 08:59:49 am »
It depends on the board, the grain of the board and if there are runoffs. 45#-50#@28" draw is possible for a 63" bow but you will have to do your part. I would back it with silk or rawhide just for insurance.
Logged
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

Offline BrokenArrow

  • Member
  • Posts: 168
Re: Bow backing
« Reply #2 on: May 06, 2014, 10:45:27 am »
Hickory is my favorite backing. I am doing a 63 inch 61 inch ntn from purpleheart backed with hickory and its 50 #
Logged
Pages: [1]
« previous next »