« previous next »
Pages: [1]

Author Topic: Saw table surface  (Read 2113 times)

0 Members and 3 Guests are viewing this topic.

Offline RyanR

  • Member
  • Posts: 833
Saw table surface
« on: February 09, 2014, 09:07:50 pm »
I have recently purchased a new Grizzly bandsaw.  It came with a protective coating on the table to keep it from rusting.  What is the best way to remove that?  I tried WD40 and a rag and it didnt do much.  It may require more elbow grease.
Logged

Offline lostarrow

  • Member
  • Posts: 1,348
Re: Saw table surface
« Reply #1 on: February 09, 2014, 10:53:23 pm »
Should say in the setup instructions. I think I used lamp oil  or autobody degreaser.(long time ago)could also call grizzly.
Logged

Offline Pat B

  • Administrator
  • Member
  • Posts: 37,633
Re: Saw table surface
« Reply #2 on: February 10, 2014, 12:26:38 am »
Maybe mineral spirits, alcohol or kerosene.
Logged
Make the most of all that comes and the least of all that goes!    Pat Brennan  Brevard, NC

Offline caveman2533

  • Member
  • Posts: 640
  • Steve Nissly
Re: Saw table surface
« Reply #3 on: February 10, 2014, 12:37:52 am »
Naptha
Logged

Offline bow101

  • Member
  • Posts: 2,235
Re: Saw table surface
« Reply #4 on: February 10, 2014, 04:06:55 pm »
And use a brillo pad with the mineral spirits, alcohol or kerosene
Logged
"The privilege of a lifetime is being who you are."  Joseph Campbell
Pages: [1]
« previous next »