question for people who cut shelfs

[bowmo]

Is the question "Why God, why?!"

[danlaw]

I started cutting shelves into my bows because I found it easier for newbies and kids to shoot (otherwise they get too discouraged). I epoxy a small strip on the belly of the handle, fade to fade. strip on the back is good too. i only use epoxy now. I tried weldbond and it seemed ok until the temperature dropped to freezing, then the glue failed completely. 

[Bryce]

Take the wrap off an THOUGHOULY inspect. Can't be too careful.





after inspection if you are still anxious about it glue a lam on the bows back  from fade to fade and then rasp it down and finish, a little added protection and it looks sharp

Bubby your reading my mind! Get out!